Schlage HandPunch 2000 - Management Menu

Programming the HandPunch
34
Management Menu
The Management menu commands allow you to manage employee data stored in a
HandPunch unit. The following section provides a brief summary of the employee data
that may be manipulated on a HandPunch unit.
Enter the appropriate password to enter the Setup command menu. Once you have
entered the command menu, there are three options available for navigating the
command menu system.
• Press # to enter the command shown on the display.
• Press * to step to the next command in the menu.
• Press CLEAR to exit the command menu (pressing any numeric key also exits the
command menu). If you are in a command’s sub-menu, press CLEAR multiple times to
completely exit the command menu.
There are four commands available from the Management command menu.
• List Users
• Set User Data
Refer to Table 7 and identify the command you need to perform. Step through all previous
commands until you reach the desired command.
Table 7: Setup Command Menu
Setup Menu
Password = 3
List Users
Display
Print
Set User Data
User Reject
Navigating
the Setup
Command
Menu
Management
Commands