Appendix D - Troubleshooting
58
This is called a “lockout.” Before the rejected ID number can be used again, another
employee or a supervisor must successfully verify at the HandPunch.
• If you enter your ID number, but do not place your hand on the platen, the HandPunch
will time-out in about 25 seconds. You can immediately end this time-out by pressing
the CLEAR key.
Beeper and LED Status During Verification
The HandPunch’s beeper and LED status display also display hand verification
information. This information is defined in Table 12.
Table 12: Beeper and LED Status During Verification
Operation Beeps LED Meaning
During Keypad
Entry
1 per Keystroke – Keystroke Accepted
After ID Entry – – OK - Proceed
After ID Entry 2 – ID Number Not in
Database
After Hand
Placement
1 Green ID Verified
After Hand
Placement
2 Red ID Not Verified -
Try Again
After Hand
Placement
1 Long
Continuous
Red ID Refused
To Next Page
Loading...