Schlage NDE80 - Install Inside Assembly; Install Backplate and Route Ribbon Cable; Align Assembly and Install on Door; Install Spring Cage

2 Align assembly and install on door.
Let the wire hang on the other side, through the hole.
WARNING
Do not pinch ribbon cable!
WARNING
Ensure that the lever catch pin is aligned with latch side
before continuing!
The latch tails must t inside the slide and the latch prongs must t into
the chassis. If the latch tails are not at the proper depth the door thickness
ring needs to be adjusted. See Door Thickness Adjustment.
Install Inside Assembly.
3 Install backplate rst, then route ribbon cable.
CAUTION
Do not pinch ribbon cable!
Route cable through indicated space.
4 Install spring cage.
Align lever catch pin to door edge. Make sure the outside escutcheon is
square before tightening the bolts.
Lever Catch Pin
Actual Size
5 Install inside escutcheon.
5a Connect the cable from the outside escutcheon to the
connector on the inside escutcheon.
5b Place inside escutcheon on backplate, and slide down
to hook onto backplate. Secure with screws. Make sure
escutcheon and spring cage are properly aligned before
tightening screws
Actual Size
1
2
3