EasyManua.ls Logo

Schlumbohm EndoPilot - Reset; Setup; Updates; Tones; Maintenance

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EndoPilot
*related to the additional module “CoPilot” - 26 - 609 2201 v12 www.schlumbohm.de
9. Reset
By re-setting, all file parameters and MyFile-settings will be set back to the factory settings.
10. Setup / Updates / Tones
In the S et up Menu, the general device information is displayed.
They may be of help especially for service and updates.
With the Menu T ones you may select individually the acoustic signals of the device.
In the sub Menu „Service“ a code can be entered. Additional functions and help-function
for the service can be enabled.
11. - 16. Appendices
11. Maintenance
You will also find information on maintenance in the instructions in chapter 16.
Check cables and connections at least every 5 months.
Attention!
Do not lubricate the motor for any reason!
Please make sure that no lubricant or cleaning liquid gets into the motor! Let excess oil drip out of
the contra-angle before using it again after maintenance. To do so, put the contra-angle in an upright position. The
contra-angle should only be lubricated before sterilisation.
Before you use the ultrasonic hand-piece, please check the insulation for any damages and make sure that the axis of
the swinger is firmly anchored in the casing. Do not use any damaged ultrasonic hand-pieces or cables.
Caution! Remove the batteries if you do not use the foot switch for a longer period of time
The EndoPilot does not contain any parts which can be repaired on-site.
If the device opened or modified, the warranty is immediately expired (see chapter 14).
A repair may only be executed by the manufacturer!

Table of Contents