Copyright © 2021 Axxiom Manufacturing, Inc.
Listed below are the warning decals and the corresponding hazards related to this equipment. Refer to
Figure 0.1(a) and 0.1(b) for images of the warning decals. Refer to Figure 0.2(a) and 0.2(b) for the
locations of these warning decals on the abrasive blaster.
1. 1
7031-002
Small “Schmidt”
Not Applicable
2. 1 7031-054
“Warning”
Airborne particle and
loud noise hazard.
Airborne particles and loud noise from blast
nozzle and blowdown can cause injury and
loss of hearing. Wear approved eye and ear
protection. See Section 1.0 and 3.10.
3. 1 7031-007B
“Danger”
Pressurized vessel.
Propelled objects will cause serious injury or
death. Depressurize vessel prior to performing
any maintenance. See Section 6.2 and 6.3.
4. 1 7031-057
“Warning”
Read manual before
using this machine.
Read and understand operator’s manual
before using this machine. Failure to follow
operating instructions could result in injury or
damage to equipment. See Section 1.0.
5. 1 7031-077
“Warning”
Pinch point hazard.
Vessel pressurization will close popup.
Closing popup can pinch and crush. Keep
hands and fingers away from popup.
6. 1 7031-082
“Danger”
Pressurized vessel
Handway components
Propelled objects will cause serious injury or
death. Incorrect or damaged handway or
manway cover components can re
sult in
failure. See Section 6.4.
7. 1
7034-001
7031-084
or decal.
General hazard and
advisory notes.
Steel “Warning” plate welded to pressure
vessel which is
a general list of required
actions to take before and during the
operation of this equipment. See Section 1.0.
1) 7031-001 / 7031-002 2) 7031-054
3) 7031-007B 4) 7031-057
Figure 0.1(a) – Warning decal summary
0.0 Warning Decal Identification and Location
To Next Page
Loading...
