SCHUBERTH E1 - Dust Filter; Retention System; Storing the Helmet; Accessories and Spare Parts

EN
6. DUST FILTER
1. Take dust lter out from behind the chin ventilation.
2. Rinse out the dust lter with cold water and, if necessary, use a mild
soapy solution. Let the dust lter dry at room temperature.
3. Re-insert after drying.
6. RETENTION SYSTEM
The metal components of the retention system do not require maintenance.
7. STORING THE HELMET
Store the helmet in the helmet bag supplied in a dry, well-ventilated and
stable place. Always position the helmet so that it cannot fall to the oor.
Damage that occurs in this way is not covered by the warranty.
Note:
Store the helmet out of the reach of children and animals.
1. COMMUNICATION SYSTEMS
Your E1 is supplied ready for installation of the SCHUBERTH
SRC-System™ as standard. The E1 is already fitted with two integrated
antennas to amplify reception and a Bluetooth
®
connection, to provide you
with the best possible radio reception.
You can find out more about the SRC-System™ from your specialist dealer.
Caution:
The installation of a communication system (including basic headsets)
constitutes a modication to the helmet. For this reason it is necessary
for any communication system and headset intended for installation
into a specic model of helmet to be tested and approved in line with
the ECE-R 22.05 European helmet standard, otherwise the helmet’s
approval and compliance with insurance requirements become invalid on
installation.
Integrated antennas for optimal
radio reception
Plug for connection with the
SRC-System™
Bluetooth
®
antenna
H. ACCESSORIES AND SPARE PARTSG. MAINTENANCE AND CARE