EasyManuals Logo

SCHUBERTH E1 User Manual

SCHUBERTH E1
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
EN
ADJUSTING THE CHINSTRAP
The length of the chinstrap is adjusted by increasing or reducing the length
of strap pulled through the metal buckles. Adjust the length of the chinstrap
so that it ts rmly but comfortably under your chin and x the end of the
strap using the retaining loop with comfort pad.
Caution:
When adjusting the strap, make sure that the helmet cannot be
pulled o in a forward direction with the chinstrap closed.
Caution:
Check the adjustment of the chinstrap length at regular intervals.
Opening and closing
To close the chinstrap fastener, slide the ratchet tongue step by step into the
locking buckle. If you nd that the chinstrap ts too loosely around your chin,
slide the ratchet tongue one step further into the locking buckle.
When adjusting the chinstrap, make sure that it rests rmly but not uncom-
fortably around your chin. To open the chinstrap, pull the red ribbon on the
ratchet fastener upwards to release the locking buckle. Then pull the ratchet
tongue out of the locking buckle.
CLOSING THE CHIN BAR
To close the chin bar, pivot it down with
one hand until both locks audibly engage.
Note:
By closing the chin guard, the shield is returned to its starting position.
Note:
Each time you close the chin bar, check that the locks have engaged
properly by pressing the chin bar upwards.
Tip:
When using the additional adjustable wind deector, locking the chin
bar is easier if you grip the chin pad underneath with a nger of your
other hand to help you ease the chin bar over your chin.
Caution:
Never ride with the chin bar raised.
10. CHINSTRAP WITH MICROLOCK
RATCHET FASTENERS
The E1 comes with a ratchet fastener. This
locking system is easy to use and
enables you to adjust the chinstrap
perfectly to your head every
time you put the helmet on.
C. THE HELMET

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SCHUBERTH E1 and is the answer not in the manual?

SCHUBERTH E1 Specifications

General IconGeneral
Shell MaterialFiberglass composite
VentilationMulti-channel ventilation system
Safety StandardsECE 22.05
PinlockIncluded
IntercomPrepared for SCHUBERTH SRC-System
VisorAnti-scratch
InteriorRemovable, washable
Closure SystemMicro-lock ratchet
Bluetooth CompatibilityYes
Chin VentAdjustable

Related product manuals