8
4. Test the retention system by doing the following:
Put your hands on the back of the helmet and try to push the helmet
o by rotating it forward.
Put your hands on the front of the helmet above your forehead (or on
the chin guard) and try to push the helmet o by rotating backward.
Warning:
If helmet comes o your head or shifts over your eyes, try another size or
another model helmet.
3. SAFETY ADVICE CONCERNING THE VISOR/
SUN VISOR
The protective lm used during shipping should be removed before use.
The anti-fog lens is supplied with a protective lm. Remove this lm
before using the helmet for the rst time.
Any scratches and/or dirt arising from the use of the visor and/or sun
visors signicantly impair your vision in any driving situation and thus
increase the risk of an accident. For your own safety, replace them or
clean them immediately.
Never use a tinted visor with marking "daytime use only" in conditions of
poor visibility, at night or in a tunnel!
Benzine, solvent and fuel vapor can cause cracks in the visor. Keep the
visor away from such vapors and do not allow these kinds of substances
to come into direct contact with the visor! Never place the helmet on the
tank of your motorcycle.
Make sure the visor is always in perfect condition. Don’t ride when visibility
is poor!
To Next Page
Loading...
