SC1
37
English
14.2.5 VOX Intercom (Default: Disable)
If this feature is enabled, you can initiate an intercom conversation with
the last connected intercom friend by voice. When you want to start
intercom, say a word such as “Hello” loudly or blow air into the
microphone. If you start an intercom conversation by voice, the
intercom terminates automatically when you and your intercom friend
remain silent for 20 seconds. However, if you manually start an intercom
conversation by tapping the (-) Button, you have to terminate the
intercom conversation manually.
However, if you start intercom by voice and end it manually by pressing
and holding the (-) Button for 3 seconds, you will not be able to start
intercom by voice temporarily. In this case, you have to tap the (-)
Button within the intercom menu to restart the intercom. This is to
prevent repeated unintentional intercom connections by strong wind
noise. After rebooting the SC1, you can start intercom by voice again.
14.2.6 HD Voice (Default: Disable)
HD Voice allows you to communicate in high-denition during phone
calls. This feature increases the quality so that the audio will be crisp
and clear during phone call conversations. If this feature is enabled,
incoming phone calls will interrupt intercom conversations and audio
from the SR10 will not be heard during intercom conversations. Three-
Way Conference Phone Call with Intercom Participant will not be
available if HD Voice is enabled.
Note:
1.
Refer to the manufacturer of your Bluetooth device that will be connected to
the headset to see if it supports HD Voice.
2.
HD Voice is active only when Audio Multitasking is disabled.
14.2.7 Smart Volume Control (Default: Disable)
Smart Volume Control automatically changes the level of the speaker
volume based on the level of the environmental noise. You can enable it
by setting the sensitivity to low, medium, or high. Smart Volume Control
responds to smaller environmental noises as the sensitivity level
becomes higher.
To Next Page
Loading...
