OPERATION
FX-520 06/16 Operation Section 4-52
© 2016 Alamo Group Inc.
OPERATION
Clutch Slips Excessively Clutch linings badly worn or Repair clutch per maintenance
plates warped. section of manuals.
Too much power for clutch. Reduce ground speed and material
intake.
Oil on facings. Replace facings.
Friction facings glazed. Clean with emery cloth.
Uneven Cut Excessive ground speed. Reduce ground speed.
Blades worn, dull, or bent. Replace blades.
(Refer to “Maintenance” section).
Mower not level side to side. Adjust. (Refer to “Assembly” section)
Improper height adjustment. Adjust Mower height.
(Refer to “Assembly” section)
Low tractor tire pressure on Adjust tire pressure. (Refer to
one side your tractor operator's manual)
Turning too fast. Reduce ground speed when turning.
Tractor tires push grass down. Adjust your tractor wheel spacing.
(Refer to “Operation” section)
Damaged Mower pan. Repair or replace as necessary.
Uncut Material Excessive ground speed Reduce ground speed.
RPM too low Use full PTO speed. (Refer to your
tractor operator’s manual)
Improper blade for direction of cut. Install blades so rotation is correct.
Poor Shredding Excessive ground speed. Raise the front of Mower relative to the
rear to hold and circulate material
longer. (Refer to the “Operation
Section-Setting the Mower-
Setting Deck Height”) Reduce ground
speed.
Cutting too high. Lower cutting height. (Refer to the
“Operation Section-Setting the Mower-
Setting Deck Pitch”)
Windrowing or Uneven Material heavy and lush. Raise the front of Mower relative to the
Material Distribution rear. (Refer to the “Operation Section-
Setting the Mower- Setting Deck
Height”)
Excessive ground speed Reduce ground speed.
Conditions too wet. Wait for conditions to dry. Reduce
ground speed.
To Next Page
Loading...