© 2016 Alamo Group Inc.
NUTS & BOLTS
Check all nuts and bolts for tightness after the first 8 hours of operation then weekly. Check the condition of
cotter pins, roll pins and other fasteners weekly and replace if necessary.
Bolt Grades and Torque
When replacing damaged bolts use only plated Grade 5 bolts unless otherwise specified. Use only bolts of
the correct length [Refer to the "Parts Manual" ]. Do not replace lock nuts with nuts and lockwashers. Use
only original equipment lock nuts.
Recommended Torques in foot pounds for SAE Grade 5 bolts, based on dry assembly: Mnt-R-0002
To Next Page
Loading...