OPERATION
FX-520 06/16 Operation Section 4-29
© 2016 Alamo Group Inc.
OPERATION
9.1 Starting the Tractor
The procedure to start the tractor is model specific. Refer to the tractor operator’s manual for starting
procedures for your particular tractor. Consult an authorized dealer if the starting procedure is unclear. Ensure
the 3-point control lever is in the lowered position and the PTO is disengaged before starting the tractor.
9.2 Brake and Differential Lock Setting
Make sure the tractor brakes are in good
operating condition. Tractor brakes can be set to
operate independently allowing single rear wheel
braking action or locked together to provide
simultaneous rear wheel braking. FOR MOST
DRIVING AND MOWING CONDITIONS, THE
BRAKE PEDALS SHOULD BE LOCKED
TOGETHER TO PROVIDE THE MOST
EFFECTIVE BRAKING ACTION.
Be aware of the operating conditions. Do not operate the Tractor with weak or faulty brakes.
When operating down a hill or on wet or rain slick roads, the braking distance increases;
use extreme care and reduce your speed in these conditions. When operating in traffic,
always use the Tractor’s flashing warning lights and reduce your speed. Be aware of traffic
around you and watch out for the other guy.
Always disengage the tractor differential lock when turning. When engaged the differential lock will prevent or
limit the tractor from turning. During normal operating conditions, locking the differential provides no benefit
and should not be used.
To Next Page
Loading...