What to do if my Schumacher SEV455 shows overvoltage?
If your Schumacher Battery Charger shows an overvoltage fault, first, unplug the charging gun and then reinsert it into your vehicle’s charging port. If the problem persists, it is recommended to consult a licensed electrician to check the AC supply.
What to do if my Schumacher Battery Charger shows undervoltage?
If your Schumacher Battery Charger is showing an undervoltage fault, unplug the charging gun and then reinsert it into your vehicle’s charging port. If the fault continues, it is recommended to consult a licensed electrician to check the AC supply.
What to do if my Schumacher SEV455 Battery Charger has a ground fault?
If your Schumacher Battery Charger is experiencing a ground fault, unplug the charging gun and then reinsert it into your vehicle’s charging port. If the issue continues, it is recommended to consult a licensed electrician to check the ground connection.
What to do if my Schumacher SEV455 shows overcurrent?
If your Schumacher Battery Charger is showing an overcurrent fault, unplug the charging gun and then reinsert it into your vehicle’s charging port.
What to do if my Schumacher Battery Charger says 'over temperature'?
If your Schumacher Battery Charger displays an 'over temperature' message, unplug the charging gun and then reinsert it into your vehicle’s charging port. If the problem continues, unplug the charging gun and allow the unit to cool down before attempting to charge again.
How to troubleshoot no AC power on my Schumacher SEV455 Battery Charger?
If your Schumacher Battery Charger has no AC power, check the breaker. It is also recommended to have a licensed electrician connect the charging station to AC power.
What to do if my Schumacher Battery Charger has leakage?
If your Schumacher Battery Charger experiences a leakage issue, re-power the unit by turning the circuit breaker off and on again. If the fault still exists, please consult a licensed electrician for help or contact our support service.
What to do if my Schumacher SEV455 shows a frequency fault?
If your Schumacher Battery Charger is showing a frequency fault, unplug the charging gun and then reinsert it into your vehicle’s charging port. If the fault continues, it is recommended to consult a licensed electrician to check the AC supply.
What to do if my Schumacher Battery Charger has a meter chip fault?
If your Schumacher Battery Charger is experiencing a meter chip fault, unplug the charging gun and then reinsert it into your vehicle’s charging port. If the issue persists, contact our support service.
What to do if my Schumacher SEV455 has a relay fault?
If your Schumacher Battery Charger has a relay fault, unplug the charging gun and then reinsert it into your vehicle’s charging port. If the issue continues, contact our support service.
Follow all safety instructions, precautions, and warnings for safe operation and to prevent injury.
Connect to a grounded system. Installation must be by a licensed electrician.
Turn off power before mounting; use conduit for AC input into the rear opening.
Insert output cable wires into the correct terminal blocks and secure the connector.
Licensed electrician must set amperage, wire size, and DIP switches per codes.
Set DIP switches to match available charging current and building meter power.
Install CT coil downstream of meter; connect cables to terminals 1, 2, and 3.
General| Brand | Schumacher |
|---|---|
| Model | SEV455 |
| Category | Battery Charger |
| Language | English |
To Next Page