SCHUNK SRU Series Short Manual

Short manual
Changing the stop on the SRU with shock absorber adjustment
Date: 13.05.2008 1 Date printed 19.05.2008
1. Replacing the “old” stops with “new” stops
(1) Loosen the screw for disassembly of the limiting sleeve (Item 10).
(These parts are not needed for the new stops).
(2) Loosen the clamp for the stops by unscrewing the screw (Item 35).
(3) Disassembly the stops A and B.
(4) Disassemble the shock absorbers by removing the safety ring.
(5) Remove all fitting disks from the hole.
(6) Mount the new shock absorbers according to the information in the table on page 2.
You can mount and adjust the new stops.
Note
On 90° units it is important to note the length of the respective stop.
Stop A
Stop A
Stop B
Stop B

SCHUNK SRU Series Specifications

General

Brand	SCHUNK
Model	SRU Series
Category	Controller
Language	English