SCHUNK SWS 001 - User Manual

Questions and Answers

J
Jamie VargasAug 11, 2025
Why is the clamping force reducing between the quick-change head and quick change adapter in my SCHUNK SWS 001 Industrial Equipment?
- J
  jose24Aug 12, 2025
  If the clamping force between the quick-change head and quick change adapter of your SCHUNK Industrial Equipment is reducing, it could be due to several reasons. First, check the sealings to ensure compressed air isn't escaping; replace them if necessary after disassembling the module. Another potential cause is excessive grease in the mechanical movement space, requiring you to clean and lubricate the product. Lastly, verify that the air supply meets the minimum pressure requirements.
H
harrelldarrellAug 21, 2025
What to do if SCHUNK SWS 001 doesn't clamp the quick-change adapter?
- S
  sancheztoddAug 21, 2025
  If your SCHUNK Industrial Equipment doesn't clamp the quick-change adapter, it might be due to a few reasons. Start by checking for dirt deposits between the SWK and SWA; if present, disassemble and clean the product. Also, ensure that the air supply meets the minimum pressure requirements. Lastly, verify the evenness of the mounting surface.
K
Karen HendersonAug 31, 2025
How to troubleshoot if balls don’t move in SCHUNK Industrial Equipment?
- M
  Martin KnappAug 31, 2025
  If the balls in your SCHUNK Industrial Equipment aren't moving, it could be due to a few reasons. First, verify that the air supply meets the minimum pressure requirements. Also, check the compressed air lines to ensure they are correctly connected. Finally, inspect the proximity switch for defects or incorrect settings; readjust or replace the sensor as needed.