schwa-medico TENStem eco basic - Switching the Control Unit (“Device”) On and Off; Starting the Application in “Ready” Mode; Adjustments During the Application in Stimulation Mode

17
2.3.4 Switching the control unit (“device”) on and o
To switch the device on, please press the
button. An audio signal will sound, the TENStem
eco basic is in “Ready” mode. Pressing the
button again in “Ready” or “Stimulation” mode:
A single audio signal will sound, the TENStem eco basic switches o. The device automat-
ically switches o if no button has been pressed for two minutes and no stimulation has
been started.
2.3.5 Starting the application in “Ready” mode
The selected programme, therapy time, frequency, pulse width and intensity are shown on
the LCD display of the device.
8. Press the P button to select a programme.
9. Pressing one of the two
buttons starts the stimulation. You will perceive a slight tin-
gling from around 10 mA.
10. Pressing the left
button: Channel 1 of the TENStem eco basic enters “Stimulation”
mode and the intensity for channel 1 increases by 1 mA per increment. The intensity
increases by 1 mA with each press of the button, until the maximum intensity of 60 mA
is reached and is shown on the LCD display. If necessary, press the
button to reduce
the intensity in the same way to reach the range that feels pleasant and right for you.
11. Pressing the right
button: Channel 2 of the TENStem eco basic enters “Stimulation”
mode and the intensity for channel 2 increases in the same way as the left channel (see
3).
Attention! If the electrodes are not correctly connected to the TENStem eco basic and
placed on the skin, the intensity will be reset to zero from a current of 9 to 10mA. Please
then rst position the electrodes correctly and restart the application by pressing the inten-
sity controls for the left and right channels
.
2.4 Adjustments during the application in “Stimulation” mode
The programme, remaining therapy time, frequency, pulse width and intensity are shown on
the LCD display during stimulation.
1. Pressing the
button stops the therapy and the TENStem eco basic goes back into
“Ready” mode.
2. Press the left
button and left button to set the individual intensity of channel 1
(from 0 to 60 mA).
3. Press the right
button and right button to set the individual intensity of channel 2
(from 0 to 60 mA).
4. Once the therapy time has ended, the stimulation is automatically stopped and the
TENStem eco basic goes back into “Ready” mode.