schwa-medico TENStem eco basic - Special Functions and Possibility of Editing Programmes; Locking the Programme Selection; Locking and Unlocking; Switching the Signal Generator Off and On

24
INSTRUCTIONS FOR USE - TENStem eco basic
5. Special functions and possibility of editing
programmes
5.1 Locking the programme selection
Press and hold the left button and the P button at the same time for three seconds (two
seconds for devices from series A and B): The programme selection function of the P button
and the editing function for programme parameters are locked.
The lock symbol
appears on the display. This function prevents a device setting chosen
for an application from being changed accidentally. Pressing the left
button and the P
button again for three seconds releases the programme selection function of the P button
and the editing function for programme parameters.
5.2 Locking and unlocking
After locking or unlocking the device, the programme must rst be started via a button.
Only then is the locking or unlocking saved and also retained after switching the device o
and on.
5.3 Switching the signal generator o and on
Simultaneously press the E button and the right button. The signal generator's current
status will be displayed after 3 seconds. "BEEP ON" means the signal generator is switched
on. "BEEP OFF" indicates that the signal generator is o. Use the E button to switch the signal
generator o and on alternately. Press the
button to save the new setting. You will then
be returned to "Ready" mode.
5.4 Special functions for devices from series A and B
Press and hold the left button and the E button at the same time for three seconds:
Display of the total stimulation duration. Pressing the E button again takes you back into
“Ready” mode.
5.5 Special functions for devices from series C
Pressing the E button takes you into “Edit” mode (see also section “‘Edit’ mode”). Press and
hold the E button for three seconds to enter “Date/time” mode (see also section “‘Date/time’
mode”).
5.6 Special functions for devices from series D
Reset all editable parameters: Press and hold the button for three seconds to reset all
editable parameters on the device to the default settings. The device conrms the execution