26
INSTRUCTIONS FOR USE - TENStem eco basic
5.9 “Memory recall” mode
Only for devices from series C:
Press and hold the left
button and the E button at the same time for three seconds to
enter “Memory Recall” mode.
If there are no values in the TENStem eco basic memory, "ZERO" will appear on the LCD
display for two seconds and the TENStem eco basic will return to "Ready" mode. Otherwise,
the LCD display will show the parameters of the last therapy session.
Programme used: P-01
Frequency: 100 Hz
Pulse width: 200 μs
Therapy duration: 0 min 44 s
Therapy day: 5
Therapy session 3
It is possible for you to save a total of 90 therapy sessions, the rst three therapy sessions
from 30 therapy days in each case.
Press the left
button to access the parameters for the previous therapy day (up to the
rst day). Press the left
button to access the parameters for the next therapy day (up to
the current day). Press the right
button to access the parameters for the previous therapy
session (up to the rst session of the respective day). Press the right
button to access the
operating parameters for the next therapy session (up to the last session of the respective
day). Press and hold the E button for ve seconds to clear the memory. “Clr” will appear for
two seconds on the LCD display and the TENStem eco basic will return to "Ready" mode.
The TENStem eco basic automatically switches o if no button has been pressed for two
minutes and it is not in stimulation mode.
To Next Page
Loading...
