Schweizer 300CB - Page 79

Normal Procedures
Pilot's Flight Manual
4-5
6. Fuel strainer, for debris or water DRAIN
7. Fuel tank vent NO OBSTRUCTIONS
8. Alternator drive belt and belt tension CHECK
9. Belt drive lower H-frame tie bar bracket and
strut for cracks and security CHECK
10. Aft crossbeam CHECK
11. Landing light CHECK
12. Rear oleo damper extension CHECK
CAU TION
If cracking of clus ter fit tings is sus pected dye penetrant
in spect in ac cor dance with HMI prior to further flight.
13. Center frame aft cluster fittings for cracks,
deformation, or damage CHECK
TAILBOOM LEFT SIDE

1. Tail rotor shaft, set alignment marks CHECK
2. Tailboom for damage or dents CHECK
3. Tailboom supports and fittings - for cracks,
deformation, damage, looseness and security CHECK
4. Static port clear of obstructions CHECK
5. Tailboom support strut end fitting for cracks,
deformation, or damage CHECK
6. Exhaust tailpipe support at tailboom CHECK
7. Exhaust diffuser installation (if installed) for
cracks, deformation, damage, looseness and
security CHECK
TAIL ROTOR

1. Tail rotor shaft alignment
Reissued: 16 Jan 2019
CHECK
SCHWEIZER
Model 269C-1 Helicopter
FAA Approved
CSP book 2..indd 79 8/4/19 12:53 PM