To park helicopter for short intervals, perform following steps:
CAUTION
To prevent rotor damage from blade flapping (droop stop
pounding) as a result of air turbulence from other aircraft
landing, taking off or taxiing, or sudden wind gusts, rotor
blades should be secured whenever helicopter is parked.
Locate helicopter in a position where there is adequate blade clear-
ance from nearby objects, on most level ground available.
Figure 7-4. Parking and Mooring
Handling, Servicing & Maint.
Schweizer RSG, LLC.
Model 269D Helicopter
7-14. PARKING (Fig. 7-4)
Pilot's Flight Manual
7-21
Rei
ssued: 16 Jan 2019
MAIN ROTOR BLADE
TIEDOWN SLEEVE
AFT FUSELAGE TIE-OFF POINT
EXHAUST/STARTER
COOLING PLUG COVER
MAST PLUG
COVER
PLENUM CHAMBER COVER
AFT TIEDOWN (LH SHOWN,
RH OPPOSITE)
STEP PLUG COVER
FWD TIEDOWN
LANDING GEAR TIE-OFF POINT
PITOT COVER
Book 3.indd 183 8/4/19 1:25 PM
To Next Page
Loading...
