Fill fuel cell (if possible).
Apply friction to lock cyclic and collective sticks.
Secure helicopter to ground by attaching restraining lines (cable or
rope), in accordance with the following:
Attach aft lines at respective ends of aft cross beam, near the
damper attach point. Tie lines to stakes/mooring anchors as
shown on Fig. 7-4.
Attach lines to the forward ends of the respective left and right
stabilizer bars, at the interface of the forward cross beam. Ex-
tend lines forward and outward at an angle that will keep lines
clear of panel skins; attach lines to forward stakes/mooring an-
chors.
7-16. SERVICING
Servicing of helicopter includes replenishment of fuel, changing or
replenishment of oil and other such maintenance functions.
Fuels, oils, and other servicing materials and capacities are listed in
Table 7-2.
CAUTION
Use extreme care when applying any type of lubrication
(grease, oil, dry-film, etc.) in vicinity of teflon bearings. Most
lubricants allow a dirt-retaining film to form, or have other
detrimental effects that can cause rapid deterioration of
bearing surfaces.
Locations of servicing points are shown in Fig. 7-5.
Handling, Servicing & Maint.
Schweizer RSG, LLC.
Model 269D Helicopter
Pilot's Flight Manual
7-23
Rei
ssued: 16 Jan 2019
Book 3.indd 185 8/4/19 1:25 PM
To Next Page
Loading...
