Schweizer RSG, LLC.
Model 269D Helicopter
Handling, Servicing & Maint.
Pilot's Flight Manual
Reissued:
16 Jan 2019
7-40A
Start engine (Section IV). After idle stabilizes, accelerate engine to
90% N
2.
Operate until oil temperature shows an increase and
ammeter reads zero.
Replenish fuel as necessary.
Open moveable air vents in each cockpit door; positioning air vents
openings downward.
Install covers and equipment used to park and moor helicopter.
Install static ground.
Avoid engine N
2
steady-state operation 71%
to 88%. Operation within the speed
avoidance range is permitted for the preflight
checks specified in this flight manual.
Transient operation through the speed range
is to be accomplished as expediently as
possible.
NOTE: Transient operation is defined as not
dwelling at any N
2
speed for more than
1 second.
CAUTION
Book 3.indd 203 8/4/19 1:25 PM
To Next Page
Loading...
