Schwinn 490e - Page 56

56
15. The console display will change to “CNFRM C4095 AGC
xx”.
16. PushtheStartbuttontoconrmandsavetheresistance
calibration values. The display will momentarily change to
“SAVING CAL”, then display “AUTO CAL_RESISTANCE”.
Calibration is complete.
Note: Pushing the Pause/Stop button will abort the
calibration process, with the new calibration values
not being saved, and the last saved calibration values
being restored.
17. Powero󰀨themachine.
18. Power on the machine. After the Power-Up/Welcome
screen appears, use the Resistance Level Quick keys 25
and1toconrmthatthemagnetcalipermovesproperly
between resistance level 1 and 25.
19. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the Owner’s
Manual.