Schwinn 490e - Moving and Storing the Machine; Leveling the Machine

6
Moving the Machine
Use the Transport Handle / Rear Step and Transport Wheels to move the machine. The Transport Handle / Rear Step is
located in the middle of the Rail Assembly at the rear of the machine. Tilt the machine forward by lifting upward with the
Transport Handle / Rear Step until the weight is on the Transport Wheels.
Roll the machine on the transport wheels to a new location. Lower your machine slowly into its new location without injury
toyourheadorngers.
Do not use the handlebars, Console Mast, or the Console to lift or move the machine. Injury to you or
damage to the machine can occur.
The machine may be moved by one or more persons depending on their physical abilities and capacities.
Make sure that you and others are all physically t and able to move the machine safely.
Place the machine on a clean, hard, level surface, free from unwanted material or other objects that may
hamper your ability to move freely. A rubber mat should be used below the machine to prevent the release
of static electricity and protect your ooring.
To prevent unsupervised operation of the machine always turn the power switch to O󰀨 and disconnect the
power cord from the wall outlet and machine power input. Place the power cord in a secure location.
Leveling the Machine
The machine needs to be leveled if your workout area is uneven or if
theRailAssemblyisslightlyo󰀨theoor.Toadjust:
1. Place the machine in your workout area.
2.SafelystandontheRearStepforapproximately20seconds.
3.Stepo󰀨themachine.
4. Loosen the locking nuts and adjust the levelers until they all contact
theoor.
Do not adjust the levelers to such a height that they detach
or unscrew from the machine. Injury to you or damage to
the machine can occur.
5. Adjust until the machine is level. Tighten the locking nuts.
Makesurethemachineislevelandstablebeforeyouexercise.
Transport Handle / Rear Step