Schwinn AD2 - Attach Seat to Seat Post; Final Inspection

6.AttachSeattoSeatPostandInstallonFrameAssembly
Note: Hardware is pre-installed on the seat and not on the hardware card.
NOTICE: Be sure the Seat is straight and tighten the hardware.
Make sure the adjustment knob (12a)engages the holes in the Seat Post.
11
X3
12 _
J
12a
\\
7.FinalInspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Be sure to record the serial number in the field provided at the front of this manual. Refer to the
Safety Warning Labels and Serial Number section of this manual.
_, o not use or put the machine into service until the machine has been fully assembled and
inspected for correct performance in accordance with the Owner's Manual.