Schwinn AD2 - Service Mode

ServiceModeletsyousettheunitsofmeasuretoeitherEnglishorMetric,seemachinestatistics
andfirmwareversion(fortechnicianuseonly).
1. WhentheConsoleisinWorkoutModeorPauseMode,pushandholddownthebuttonfor
5secondstogointoServiceMode.
Note:TapthebuttontomovethroughtheServiceModeMenuoptions.WhentheConsole
displayshows"dOnE",pushandholdthebuttonfor3 secondstoresettheworkout
dataandgobackto WorkoutMode.
2. TheConsoledisplayshowstheUnitsprompt.PushandholdthebuttontostartUnits
option.Pushthebuttontochangebetween"LbS"(Englishunits)and"SI"(metricunits).
3. Pushandholdthebuttonfor3secondstosettheunits.TheConsoledisplayshowsthe
Unitsprompt.
4. PushthebuttontogototheStatsprompt.Pushandholdthebuttontostartthemachine
Statsoption.TheConsoledisplayshowsTotalDistance.Pushthebuttonto change
betweenTotalDistanceandTotalTime.
.
6.
.
8.
Note: The Total Distance value is a whole number of miles/km (no decimal point).
Push and hold the button for 3 seconds to go back to the Stats prompt.
Push the button to go to the Firmware Version prompt. Push and hold the button to see the
firmware version of the Console.
Push and hold the button for 3 seconds to go back to the Firmware Version prompt.
Push the button to go to the exit option. The Console display shows "dOnE".
To go back to Workout Mode, push and hold the button for 3 seconds. The workout data is
reset.
To go through the Service Mode Menu again, tap the button. The Console display will show
the Units prompt.
In Service Mode if the Console does not receive any input in approximately 5 minutes, it goes
into Sleep Mode.