Schwinn IC2 - Page 58

58
B
E
G
J
H
K
B
E
C
A
F
X2
16. Loosen the Hex Head Bolt (C) that attaches each Flywheel
Retainer Clip (A) to the Frame. Remove the Hex Head Bolts,
Flywheel Retainer Clips and Nuts (F) from the Frame. Keep the
hardware safely aside for reassembly.
17. Carefully move the Flywheel (G) to the opening in the flywheel
brackets (B). Carefully lift it from the brackets and lift the Drive
Chain (H) off the Flywheel sprockets (J) to the outside.
NOTICE: This step may require two people.
18. Remove the old Flywheel assembly (G) and set it safely aside
to discard.
Be sure to keep fingers clear of all pinch hazards as
you turn the Sprocket Drive (K) and Flywheel (G).