Scion Instruments 456-GC - On Column Injector

Page: 109
436-GC/456-GC
710 Injectors
SCION Instruments
436-GC/456-GC Service Manual Revision B February 2019
On Column Injector
1. a. Injector Nut CP8400/8410 (392595501 default
b. Injector Nut (390812700)
Injector Nut Wrench, 390842300
2. Automatic Start Switch (390820601)
3. Septum, 9.5 mm
BTO (lowest bleed, CR298705)
Marathon (Auto sampler, CR239188)
Advanced Green 3 (general purpose, CR246124)
4. Injector Body
EFC23 type (392548201)
5. Injector Body Ferrule
40% Graphite/60% Vespel (up to 400°C), CR213400
Graphite (up to 450 °C), CR211400
6. Injector Body Nut (Stainless Steel, SWSS4021)
7. Injector Insert (Stainless Steel, 392543101)
Injector Insert (For Headspace injection, CP742552)
8. Column Ferrule, see table below
9. Capillary Nut (394955100)
10. Temperature Probe (392537401)
11. Heater, 120V 125W- 392539601
230V 125W- 392539602
Column ID
Teflon
Max 250°C
Vespel
Max 350°C
40% Graphite
/60% Vespel
Max 400°C
Graphite
Max
450°C
SilTite
Metal, GC/MS
0.53 mm ID
CR214108
CR212108
CR213108
CR211108
SG073302
1a
1b
2
3
4
5
10
6
11
7
8
9