Scion Instruments 456-GC - Page 191

436-GC/456-GC
910 Technical information
Page: 190
SCION Instruments
436-GC/456-GC Service Manual Revision B February 2019
15) When a sampler is installed on the 436-GC/456-GC then only the Bruker GC-450 driver
must be installed.
16) Press OK .
17) Press Yes to access the system.
18) Select communication and press the magnifying glass to see the instrument or type in the IP
address.
19) Press
20) The following messages should appear:
• Parameters activated
• Setup received from instrument
21)Press OK.