ScorpionTrack Cat 5 Installation Guide V3 17.03.17 Page | 10
If the installer receives a text stating that one or both driver card batteries are low,
they will need to charge the card/s. This will take around 30 minutes to charge from
fully flat.
Please Note: If the installer has NOT received any text message, the unit has not
been able to commission and they should refer to the troubleshooting guide at the
end of this document or call Tracking Support on 01257 249928 option 2.
10. Programming in additional or replacement driver cards
The system can accept up to a maximum of 10 cards. These will need to be
programmed in to the system by calling Tracking Support on 01257 249928 option 2.
The vehicle registration will be required in each instance in order to send the
commands to the unit:
Additional Cards:
The engineer will need to have all cards, including the original existing tags, with fully
charged batteries present before calling tracking support.
Lost or damaged Card:
Tracking Support will need to be supplied with the serial number(s) of existing cards
so that lost or damaged cards can be deleted from the system.
If the sticker displaying the unique card number has been damaged or is illegible,
contact Tracking Support on the above number and they will be able to assist.
Vehicle CK66UDL
Keys: 011489D6 paired battery ok,
011489E1 paired battery low.
To Next Page
Loading...
