ScorpionTrack Cat 5 Installation Guide V3 17.03.17 Page | 5
4. Permanent 12v or 24v power supply (+30) Red Wire
Connect the permanent power supply to either 12 or 24 volt using the in-line 5 amp
link fuse (supplied) using soldered or approved crimp connections. It is also
important to check that the supply is a constant feed and does not time out due to
on board vehicle power management.
Please Note: It can take some time after the car is locked for some feeds to drop out,
please double check if unsure. Do not connect directly to the vehicle’s radio circuits
as this may cause interference.
5. Ignition (+15) Orange Wire
Locate a 12 or 24 volt ignition supply that remains constant while cranking the
engine. Connect the ScorpionTrack 5 orange wire to this ignition supply using a
soldered or approved crimp connection, then insulate.
Please Note: It is imperative that the ScorpionTrack 5 has a good ignition power
supply. Do not connect directly to the vehicle’s radio circuits as this may cause
interference.
To Next Page
Loading...
