KeyPad service manual
Rev.1.1
1.6.5 Setting the Timer
Enter the required ‘Target Time’ (minutes). The Target Time is the required time
at the designated Target Temperature. To change the Target Time, use the
numeric keypad and over write with the desired value.
Press
1.6.6 Programming Heater Shut Down
Select ‘OFF’ to turn the heater off at the end of the Target Time. Select ‘ON’ if
you wish to maintain the block at the previously set Target Temperature at the
end of the Target Time.
Press
1.6.7 Alarm Mode
Press the ‘Alarm Button’ to turn on the alarm. ‘AL’ will be displayed to indicate the
alarm is on. A second press of the button will toggle the Alarm off. The timer will
sound an audible alarm if the alarm is selected.
To reset the timer/alarm, press the ‘Target Time’ button to return to the Timer
screen and enter a new Target Time. Continue to follow the previous instructions
mentioned above.
TARGET TIME?
0 TO 999 XXX
END OF TIME?
HEATER OFF ON
TEMPERATURE 95.0 C
TIME 120:23 AL
To Next Page
Loading...
Need help?
General
