Manual Version 19 / 01-2019 II Page 34 of 44
SF2 ECCR OPERATION MANUAL
Flush the head with oxygen for about 5 seconds and then wait about 10 seconds.
Repeat this process 2-3 times until the sensors have stabilized. When the sensors
stop swaying in their readings, press lightly
Gas flow (0.5-5 l / min) to "Calibrate" and wait for confirmation. Usually the
Calibration value set to 98% because it is assumed that there is a certain residual
moisture and that the system is not 100% flushed. Calibrate the backup computer /
monitor or the HUD in the same way!
To Next Page
Loading...