Scuba Force SF2 ECCR - Chapter 11 - Attachement; Checklist

Manual Version 19 / 01-2019 II Page 42 of 44
SF2 ECCR OPERATION MANUAL
12. Attachment
11.1 Checklist
SF2-CCR Checklist
ASSEMBLY
1.
Check all cylinders for content and pressure (O2,
Diluent, Argon, Stages
2.
OPV closed, soda lime checked and installed
3.
Calibration (if necessary)
4.
Loop Test
5.
QD-connections 1+2+3 shut, Pony clamps closed,
all hoses tight
6.
Positive Test
7.
Negative Test
PREDIVE-CHECK
1.
Controller switch on  Loop breathing
2.
O2 cylinder open  Solenoid / Shut-off check
 Solenoid is firing oxygen  O2 MAV / Shut-
off check  Pressure check  closing O2
cylinder
O2
Seite
3.
Switch Setpoint to 0.19, Breathe empty loop
4.
Diluent Tank open  ADV / Shut-off check 
DIL MAV / Shut-off check  Wing Inflator 
Pressure check  closing DIL Tank
DIL Seite
5.
Check controller settings (plan, gases, battery,
functions
PREJUMP-CHECK
1.
Equipment check (Light, SMB, Mask etc.)
2.
Open cylinders, switch on Controller, Inflator
connected
3.
pO2 > 0,7  Breath from Loop