Manual Version 19 / 01-2019 II Page 30 of 44
SF2 ECCR OPERATION MANUAL
6.2 Assembly Regulator, Wing & Harness
The assembly of the accessories requires a little manual skill and basic knowledge of
diving equipment. Don't try this alone. Your SF2 diving instructor is at your side with
words and deeds and, in addition to the assembly, will also carry out the individual
size adjustment together with you.
After the bottles have been
attached to the SF2, the
regulators can be screwed on.
It is advisable to put the device
down as this makes work
easier.
The low-pressure hoses must
be unscrewed from the
manual adds, as they are a
hindrance during assembly.
If the low-pressure hoses are equipped with Quick Disconnect, in the “Ready to Dive”
variant, they can simply be clicked on. The connectors have a "lock" function that is
activated by turning the black ring. This prevents the hoses from accidentally jumping
off. Without Quick Disconnect, the hoses are simply tightened hand-tight with an open-
end wrench.
To Next Page
Loading...