Manual Version 19 / 01-2019 II Page 38 of 44
SF2 ECCR OPERATION MANUAL
8.5 Prejump-Check
• Check that your equipment is complete (lamps, masks, buoys, etc.)
• Open the diving tanks and bailout stages.
• Check the inflators (wing and dry suit).
• Switch on the controller and the monitor.
• Set the pO2 to> 0.7 bar with the oxygen MAV and breathe the loop as a test.
WARNING
Always turn on the controller BEFORE going into the water.
The controller only switches itself during the immersion phase
automatically. If you swim on the surface and breathe through
the loop, life-threatening hypoxia can occur.
LET´S GO DIVING!
To Next Page
Loading...