ACTIVE TECHNOLOGIES (iCONTROL)
unlikeanautomotivetypecruisecon-
trol which maintains a constant speed
while throttle pedal is released.
As you proceed under a constant cruis-
ing speed setting, hold the throttle
lever fully depressed in order to keep
your full attention to maintaining good
situational awareness.
Refer to
OPERATING MODES
subsec-
tion for detailed instructions.
Slow Speed Mode (if equipped with
Cruise M ode)
Slow speed mode is a functio n
of cruise mode which allows the
operator to adjust and set idle
speed corresponding to a water-
craft speed of 1.6 km/h to 11 km/h
(1 MPH to 7 MPH). The throttle leve r
should not be depressed while operat-
ing in slow speed mode.
Refer to
OPERATING MODES
subsec-
tion for detailed instructions.
Ski Mode (if equipped)
Ski mode allows for a controlled launch
and accurately maintained maximum
towing speed when towing a skier or
wake boarder.
Refer to
OPERATING MODES
subsec-
tion for detailed instructions.
O.T.A.S.
TM
System
(Off-Throttle Assisted Steering)
The O.T.A.S. (Off-Throttle Assisted
Steering) system prov ide s additional
maneuve ra bility in off-throttle s itu a-
tions.
The OTA S system is e lectronically ac-
tivate d when the operator initiates a
full turn and releases the throttle at the
same time.
Limitations
The O.T.A.S. system cannot help you
maintain control o r prev en t collisions
in all situation s.
Refer to
OPERATING INSTRUCTIONS
subsection for details.
Learning Key and Rental Key Modes
The Sea-Doo
TM
learning key limits the
speed of the watercraft therefore en-
abling first tim e users and less expe-
rienced operators to learn how to op-
erate the watercraft while gaining the
necessary confidence and control.
The rental key is applicable only to
rental models. It f unctions similarly
asalearningkey.
Limitations
The ability of a novice to operate th e
watercraft can be exceeded even
when a learning or rental key is used.
Refer to
OPERATING MODES
subsec-
tion for details.
iBR (intelligent Brake
and Reverse System) (All
Models Except GTS)
This watercraft uses a n e lectronic ally
controlled bra king and reverse sy stem
called the iBR system (intelligent Brake
and Reverse).
The iBR module controls the position
of the iBR gate to provide:
– Forward
– Reverse
–Neutral
–Braking.
The operator commands the position
of the iBR gate using either the throttle
lever for forward positio n, or the iBR
lever for neutral, reverse, and for the
braking function.
NOTE: The iBR lever can only be used
to command a change in the gate posi-
tion if the engine is running.
Using t he iBR system significantly re-
duces the stopp ing distance of this
watercraft and can increase its maneu
-
verability as it ca n be used in a straight
line, in a turn, at high or low speeds, or
________
SAFETY INF
ORMATION
________
17