41
PRE-OPERATION CHECKS
Some of the following items may not have been previously covered in this guide,
however they will be described in the MAINTENANCE or SPECIAL PROCEDURES
section. Please refer to these sections to have more detailed information.
NOTE: See the detailed instructions hereinafter.
WARNING
The pre-operation check is very important prior to operating the watercraft.
Always check the proper operation of critical controls, safety features and
mechanical components, before starting as listed hereinafter. If not done
as specified here, severe injury or death might occur. Bring all safety equip-
ment required by local laws.
WARNING
Engine should be off and the safety lanyard should always be removed
from its post prior to verifying any of the following points. Only start wa-
tercraft once all items have been checked and operate properly.
ITEM OPERATION ✓
Hull Inspect.
Jet pump water intake Inspect/clean.
Bilge Drain. Ensure plugs are secured.
Battery
Inspect tightness of cables and retaining
strap(s).
Fuel tank and oil reservoir Refill.
Engine compartment
Check fuel line connections for tightness.
Verify for any fuel leak/odor.
Steering system Check operation.
Throttle system Check operation.
Shifter system Check operation.
Storage compartment covers and
seat
Ensure they are closed and latched.
Safety lanyard and engine
start/stop button
Check operation.
smo2003-005a.book Page 41 Friday, November 1, 2002 8:25 AM
To Next Page
Loading...
Need help?
General