51
Flushing
To flush cooling system, start the en-
gine then immediately open the water
tap.
CAUTION: Never flush a hot engine.
Always start the engine before open-
ing the water tap. Open water tap
immediately after engine is started
to prevent overheating.
Run the engine about 3 minutes at a
fast idle around 3500 RPM.
Ensure water flows out of drain lines
(engine crankcase, engine cylinder and
air compressor while flushing. Other-
wise, clean the lines.
CAUTION: Never run engine longer
than 5 minutes. Drive line seal has
no cooling when watercraft is out of
water.
Lubrication
Spray BOMBARDIER LUBE lubricant
or equivalent, through hole of air intake
silencer keeping engine at fast idle
during one minute.
1. Air intake silencer
2. Spray BOMBARDIER LUBE here
Close the water tap then stop the en-
gine.
CAUTION: Always close the water tap
before stopping the engine.
Final Steps
Disconnect the garden hose.
Remove spark plug cables and connect
them on the grounding device.
1. Grounding device
Remove both spark plugs and spray
BOMBARDIER LUBE lubricant or equiv-
alent into each cylinder.
To prevent fuel to be injected and also
to cut the ignition at the engine start-
ing, proceed as follows.
While engine is stopped, fully depress
throttle lever and HOLD for cranking.
NOTE: A 1 second beep every second
indicates the drowned mode is active.
Crank the engine a few turns to distrib-
ute the oil on cylinder wall.
Apply anti-seize lubricant on spark plug
threads then reinstall them.
WARNING
Components inside engine com-
partment may be hot. Do not touch
any electrical parts or jet pump
area when engine is running.
F02H0ZY
1
2
WARNING
Always use spark plug cable ground-
ing device when removing spark
plugs.
1
F01H7DY
smo2003-005a.book Page 51 Friday, November 1, 2002 8:25 AM
To Next Page
Loading...
Need help?
General