Name: Sea Tel 3011W-91
Brand: Sea Tel
Rating: 5 (1 reviews)

To Next Page

Sea Tel, Inc.

4030 Nelson Avenue

Concord, CA 94520

Tel: (925) 798-7979

Fax: (925) 798-7986

Web: http://www.cobham.com/seatel

Sea Tel Europe

Unit 1, Orion Industrial Centre

Wide Lane, Swaythling

Southampton, UK S0 18 2HJ

Tel: 44 (0)23 80 671155

Fax: 44 (0)23 80 671166

Web: http://www.cobham.com/seatel

Sea Tel Inc is also doing business as Cobham Antenna Systems

January 30, 2012 Document. No. 136407 Revision A

INSTALLATION MANUAL

FOR SEA TEL 3011W-91 BROADBAND-AT-SEA

TRANSMIT / RECEIVE SYSTEM WITH SELECTABLE CO-POL OR

CROSS-POL RECEIVE

Default Chapter1
- Installation Manual1
- Table of Contents5
1 System Configuration(S)10
- System Cables10
- Other Inputs to the 1.3. Simplified Block Diagram of a 3011 System10
- Dual Antenna Configuration11
- Dual Antenna Arbitrator12
- Open Antenna-Modem Interface Protocol (Openamip™) Specification12
2 Site Survey14
- Site Selection Aboard Ship14
- Antenna Shadowing (Blockage) and RF Interference14
- Mounting Foundation15
- Mounting Height16
- Mast Configurations16
- Safe Access to the Ade18
- Below Decks Equipment Location18
- Cables18
- Grounding19
3 Installation20
- Unpacking and Inspection20
- Assembly Notes and Warnings20
- Installing the Ade21
  - Prepare the 50", 60", 66" or 76" Radome Assembly21
  - Installing the 50, 60 or 66" Radome Assembly22
- Removing the Shipping/Stow Restraints PRIOR to Power-Up25
- Cable Installation28
  - Shipboard Cable Installation28
- Installing the below Decks Equipment28
- Connecting the below Decks Equipment29
- Final Checks33
  - Visual/Electrical Inspection33
  - Electrical - Double Check Wiring Connections34
- Power-Up34
4 Basic Setup of the Acu38
- Operator Settings38
- Setup Parameter Display and Entry Menus38
- Default Setup Parameters for Your Antenna38
- Save New Parameters39
5 Setup - Ships Gyro Compass40
- Gyro Type40
- Pdating the Gyro Type Parameter40
  - Compass40
6 Setup - Tracking Receiver - Vsat42
- Determining the if Tracking Frequency (Mhz)42
- Khz42
- Fec42
  - L-Band SCPC Receiver42
- Tone42
  - VSAT Application42
- Volt43
- Sat Skew43
- Nid43
7 Setup - Band Selection44
- Cross-Pol Only Quad-Band LNB45
- Cross-Pol and Co-Pol Single-Band Lnbs45
- Cross-Pol and Co-Pol Quad-Band Lnbs46
8 Setup - Targeting48
- Auto Trim48
- Manually Optimizing Targeting48
- El Trim49
- Az Trim49
9 Setup - Home Flag Offset50
- Electronic Calibration of Relative Antenna Position (Home Flag Offset)50
- Mechanical Calibration of Relative Antenna Position (Home Flag Offset)53
10 Setup - Searching54
- Searching Operation54
- Changing the Search Parameters57
- Save New Parameters58
11 Setup - Blockage & Rf Radiation Hazard Zones60
- Radiation Hazard and Blockage Mapping (AZ LIMIT Parameters)60
- M Apping (Az Limit Parameters )60
- Save New Parameters63
12 Setup - Modem Connections, Setup and Test64
- Jumper Selection64
- Idirect Modems65
- Comtech Modems65
- Hughes Modems66
- Stm Modems66
- Connections (ACU to Satellite Modem)66
- Blockage Simulation Test - Dac-220268
- Testing the Satellite Modem Lock Input - Dac-220269
- Save New Parameters69
13 Setup - Optimizing Polarity & Cross-Pol Isolation70
- Sat Skew Setting70
- Polarity Angle (Polang) Parameters70
- Optimizing Auto-Polarization on Receive Signal70
- Optimizing Auto-Polarization Cross-Pol Isolation71
14 Setup - Other Parameters72
- Setup Parameter Display and Entry Menus72
- OFFSET (May Not be in Your Software)72
- SCALE (May Not be in Your Software)72
- Remote Command72
- Remote Monitor72
- To Disable/Enable Dishscan72
- Satellite Reference Mode73
- Remote Parameters73
15 Functional Testing74
- Acu / Antenna System Check74
- Latitude/Longitude Auto-Update Check74
- Heading Following74
- Blockage Simulation Test74
- Four Quadrant Test Tracking75
- Blockage Simulation Test76
- Test Broadband Operation76
  - Over Ip (Voip) Operation77
16 Installation Troubleshooting78
- Warranty Information78
- Troubleshooting the Acu78
  - ACU Display Is Blank79
  - ACU Status Displays "REMOTE NOT RESPONDING79
- Troubleshooting Ships Gyro Compass Problems79
17 Stowing the Antenna for Underway with Power off82
- Installing the Stow Restraints82
- Removing the Shipping/Stow Restraints PRIOR to Power-Up85
18 Dac-2202 Technical Specifications88
- Dac-2202 Antenna Control Unit88
- Terminal Mounting Strip90
- Environmental Conditions91
- Dac-2202 Ac Power Consumption91
- Cables92
  - IF Signal Cables92
  - Sbs/Synchro Gyro Compass Interface Cable (Customer Furnished)92
91 Technical Specifications94
- Antenna Reflector/Feed 301194
- Smw Quad Band Lnb94
- TX Radio Package ( -91 Systems)95
  - OPTIONAL 7550 M&C Interface Unit95
  - OPTIONAL 7552 FSK to USB M&C Interface Unit95
- Buc Power Supply95
- Co-Pol Equipment95
- Mk 2 Pedestal Control Unit (Pcu)96
- Mk 2 Motor Driver Enclosure (Mde)96
- Mh Z Base & Pedestal Unlimited Azimuth Modems (3 Channel )97
- Stabilized Antenna Pedestal Assembly97
- Radome Assembly , 4098
- Ade Pedestal Power Requirements99
- Xx10 Environmental Specifications99
- Below Decks Equipment99
- Cables100
20 Drawings102
- Dac-2202 Antenna Control Unit Drawings102
- 3011W-91 Ku-Band Model Specific Drawings102
- 3011 General Drawings102

Sea Tel 3011W-91 User Manual

Table of Contents

Questions and Answers:

Sea Tel 3011W-91 Specifications

Related product manuals

Brand	Sea Tel
Model	3011W-91
Category	Antenna
Language	English