DOCS-001 Manual, SeaBotix Inc. Users, 150 – 200 Series - Rev B – 27 Jan 10 - Page 30 of 64
2. Temperature
a. Pressing the 2 key will allow you to calibrate the temperature display
on the Video Overlay.
To adjust the temperature value:
Press key 1 to increase the value
Press key 2 to decrease the value
Press key 3 to reset the value
3. Depth
a. Pressing the 3 key will allow you to calibrate the depth information on
the Video Overlay.
To adjust the depth value:
Press key 1 to increase the value
Press key 2 to decrease the value
Press key 3 to set to zero
Press key 4 to reset to default
Press key 5 to set the slope
4. Compass & Heading
a. Pressing the 4 key will allow you to calibrate the compass heading
information on the Video Overlay.
To calibrate the compass, refer to page 14, section 1.8 “Calibrating Compass” for
more information.
5. Monitor
a. Pressing the 5 key will allow you to adjust the RF gain on the monitor.
Should there be interference in the monitor picture, try adjusting the RF
gain up or down to clean up the picture.
To adjust the RF Gain value:
Press key 1 to increase the value
Press key 2 to decrease the value
Press key 3 to reset the value
To Next Page
Loading...