48
Hull
Inspect hull for cracks or damage.
Jet Pump Water Intake
Remove weeds, shells, debris or any-
thing else that could restrict the flow
of water and damage exhaust cooling
system or propulsion unit. Clean as
necessary. If any obstruction can not
be removed, refer to an authorized
Sea-Doo dealer for servicing.
INSPECT THESE AREAS
1. Water intake
2. Ride plate
Inspect leading edges of the impeller,
if they have nicks or bends performance
will be greatly reduced.
Inspect for any possible coolant leak
from ride plate.
Bilge
Should water be present in the bilge,
tilt the watercraft to the rear and un-
screw drain plugs to completely empty
the bilge.
Secure bilge drain plugs.
Battery
Fuel Tank
With the watercraft horizontal, fill the
fuel tank to specified level.
Check fuel tank retaining straps/fasteners.
Engine Compartment
Engine Oil Level
Ensure oil level is appropriate as spec-
ified in LIQUIDS section. Check for oil
leaks on engine and in engine com-
partment.
WARNING
When operating the engine while
the watercraft is out of the water,
the heat exchanger in the ride
plate may become very hot. Avoid
any contact with ride plate as
burns may occur.
F18J04Y
21
WARNING
Make sure drain plugs are proper-
ly secured prior to launching the
watercraft in water.
WARNING
Verify tightness of battery cables to
their posts and condition of battery
retaining fasteners. Do not charge
or boost battery while installed.
WARNING
Should any leak or gasoline odor be
present, do not start the engine. Re-
fer to an authorized Sea-Doo dealer
before use.
smo2002-003_a.book Page 48 Friday, October 12, 2001 2:04 PM
To Next Page
Loading...
Need help?
General
