69
Throttle Cable Inspection
Throttle Cable
Depress and release the throttle lever.
It should operate smoothly and return
to its initial position without any hesi-
tation. There must be a small amount
of free-play when throttle lever is re-
leased. Refer to an authorized Sea-Doo
dealer if necessary.
CAUTION: Never attempt to adjust
the idle speed through the throttle
body tamper proof screw. If so, it
would impair the idle speed stabili-
ty. Besides, no adjustment could be
performed by the dealer nor the fac-
tory to correct the idle speed. The
throttle body would need to be re-
placed at the customer expense.
Also take into account that might
change the engine emission level
and the engine might not meet the
EPA/CARB requirements.
1. Should move freely
2. Slight free-play must be present here
Engine Oil Change and Oil
Filter Replacement
The oil change and filter replacement
should be performed by an authorized
Sea-Doo dealer.
Valve Adjustment
There is no valve adjustment to be per-
formed on this engine.
Coolant Replacement
The coolant replacement should be
performed by an authorized Sea-Doo
dealer.
Fuel Injection System
The fuel injection system inspection
should be performed by an authorized
Sea-Doo dealer. Fuel system pressur-
ization should be conducted at the
same time.
Steering Alignment
When the handlebar is directed in straight
ahead position, the jet pump nozzle
should be in the same direction allowing
the watercraft to run in a straight line. The
rear edge of side vanes should be point-
ing out side by 20° when the handlebar is
pointing straight ahead.
1. Approximately 20° when handlebar is pointing
straight ahead
WARNING
Do not alter or tamper with throt-
tle cable adjustment or routing.
WARNING
If throttle lever does not automat-
ically return, do not operate wa-
tercraft and see your authorized
Sea-Doo dealer.
F01K01Z
1
2
F18L0ZZ
1
1
smo2002-003_a.book Page 69 Friday, October 12, 2001 2:04 PM
To Next Page
Loading...
Need help?
General
