SeaDoo GTX 4-Tec Series User Manual

79
Pre-Season Preparation Chart
NOTE: It is highly recommended that an authorized Sea-Doo dealer perform the
annual safety inspection and factory campaigns in addition to the pre-season prep-
aration all at the same time.
➀ Before installing new spark plugs, it is suggested to burn the excess BOMBARDIER
LUBE lubricant or equivalent by starting the engine using the old spark plugs.
➁ Safety item covered in the annual safety inspection.
OPERATIONS
TO BE
PERFORMED
BY
GENERAL
Lubrication/corrosion protection Operator
Spark plug replacement ➀ Dealer
ENGINE
Exhaust system condition and fasteners) Dealer
Condition of seals and fasteners Dealer
Oil level Dealer
COOLING
SYSTEM
Inspection of cooling system coolant level, hoses and
components
Dealer
FUEL
SYSTEM
Fuel filter replacement Dealer
Fuel injection sensors verification Dealer
Fuel system; check valves, lines, fasteners,
pressurization ➁
Dealer
Filler neck, fuel tank and fuel cap condition ➁ Dealer
Fuel tank straps Operator
Refill fuel tank Operator
ELECTRICAL
SYSTEM
Battery condition/charging and reinstallation. Set the time
and preferences in information center.
Dealer
Battery, starter connections and routing ➁ Dealer
Monitoring beeper Dealer
Digitally encoded security system Dealer
STEERING
SYSTEM
Steering system adjustment/inspection ➁ Dealer
O.P.A.S.
SYSTEM
Check O.P.A.S. system condition including filter.
Replace all 8 square rings
Dealer
PROPULSION
SYSTEM
Shifter system condition and cable adjustment Dealer
Propulsion system inspection Dealer
HULL AND
BODY
Inspection of bailer pick-ups Dealer
smo2002-003_a.book Page 79 Friday, October 12, 2001 2:04 PM

SeaDoo GTX 4-Tec Series Specifications

General

Seating Capacity	3
Rider Capacity	3
Manufacturer	BRP (Bombardier Recreational Products)
Category	Personal Watercraft (PWC)
Engine Type	4-stroke
Fuel Type	Unleaded gasoline
Width	48 in (122 cm)