SeaDoo GTX 4-Tec Series User Manual

81
Information Center Messages
CODED SIGNALS POSSIBLE CAUSE REMEDY
A 2 seconds beep every
15 minutes interval.
• Watercraft is upside down.
Turn watercraft upright. Refer to
SPECIAL PROCEDURES.
• Engine coolant temperature
sensor or circuit malfunction.
Refer to an authorized Sea-Doo
dealer.
• Exhaust temperature sensor or
circuit malfunction.
Refer to an authorized Sea-Doo
dealer.
• Engine oil pressure sensor or
circuit malfunction.
Refer to an authorized Sea-Doo
dealer.
• Low pressure in oil separator
tank (engine oil leak).
Refer to an authorized Sea-Doo
dealer.
• TOPS sensor or circuit
malfunction.
Refer to an authorized Sea-Doo
dealer.
• TOPS valve solenoid or circuit
malfunction.
Refer to an authorized Sea-Doo
dealer.
• Engine ECU failure.
Refer to an authorized Sea-Doo
dealer.
• Bilge pump circuit low or high
voltage (if so equipped).
Refer to an authorized Sea-Doo
dealer.
• Starter solenoid circuit
malfunction.
Refer to an authorized Sea-Doo
dealer.
Continuously beeps.
• High engine temperature cool-
ant.
See engine OVERHEATING.
• High exhaust temperature.
Refer to an authorized Sea-Doo
dealer.
• Low engine oil pressure.
Refer to Engine Low Oil Pres-
sure in SPECIAL PROCEDURES.
OBSERVATION POSSIBLE CAUSE REMEDY
The information center dis-
play abbreviated messages
that I don’t understand.
• Some messages are useful
navigational information and
others may be system fault in-
formation.
Refer to Information center in
controls, COMPONENTS AND IN-
STRUMENTS FUNCTIONS.
No numbers are displayed in
the usual display and only
P-XXXX numbers appear in
the message area.
• ECU has been inadvertently set
to onboard diagnostic mode.
Remove and reinstall safety lan-
yard.
smo2002-003_a.book Page 81 Friday, October 12, 2001 2:04 PM

SeaDoo GTX 4-Tec Series Specifications

General

Seating Capacity	3
Rider Capacity	3
Manufacturer	BRP (Bombardier Recreational Products)
Category	Personal Watercraft (PWC)
Engine Type	4-stroke
Fuel Type	Unleaded gasoline
Width	48 in (122 cm)