Need help?Do you have a question about the Seagate Spinpoint M8 and is the answer not in the manual?
Lists the main features and capabilities of the Spinpoint M8 drive.
Lists performance metrics like seek time, latency, and transfer rates.
Provides data on error rates and Mean Time Between Failures (MTBF).
Provides instructions and cautions for physically mounting the drive.
Describes the SATA power and data connectors.
Explains the point-to-point SATA connection and absence of jumpers.
Illustrates how to connect the SATA interface and power cables for installation.
Details the sealed mechanical components of the drive.
Details the components on the PCBA that provide drive intelligence.
Controls head positioning and compensates for offsets and vibration.
Describes the read and write channels' signal paths and data processing.
Lists and describes key firmware features of the drive.
Explains how read caching enhances performance by prefetching data.
Improves write performance by buffering data before writing to disk.
Describes how defective sectors are handled during manufacturing and operation.
Explains Self-monitoring, Analysis, and Reporting Technology for predicting failure.
Details registers used for commands like Data, Features, and Status.
Enhances performance by allowing command reordering.
Lists supported ATA commands and their parameters.
Details specific ATA commands and their functions.
Performs internal diagnostic tests on the drive.
Retrieves device identification data from the drive.
Issues NCQ read commands, allowing reordering.
Individual SMART commands identified by Feature register values.
Lists safety and handling precautions for servicing the drive.
Avoid opening the sealed compartment to prevent damage and warranty void.
General| Rotational Speed | 5400 RPM |
|---|---|
| Capacity | 500GB, 750GB, 1TB |
| Form Factor | 2.5 inch |
| Operating Temperature | 0°C to 60°C |
| Non-Operating Temperature | -40 to 70°C |
| Shock Resistance (Non-Operating) | 1000G |
To Next Page
