33
13.
14.
1.
INSTALLING THE RECEIVER SWITCH
Install the switch into the precut hole
in the side, in the fuselage.
3/32” Hole
.
2.
3.
.
1.
INSTALLING THE ENGINE SWITCH
2.
Trim and cut
Trim and cut
INSTALLING THE STOPPER
ASSEMBLY
Using a modeling knife, carefully cut
o the rear portion of one of the 3 nylon
tubes leaving 1/2” protruding from the
rear of the stopper. is will be the fuel
pick up tube.
Switch
Switch
To Next Page
Loading...
