9
Use dental oss or heatshrunk tube to
secure the connection so they cannot be-
come unplugged.
7.
Secure the servo to the aileron hatch us-
ing Phillips screwdriver and the screws
provided with the servo.
Apply 1-2 drops of thin C/A to each of
the mounting tabs. Allow the C/A to cure
without using accelerator.
C/A glue
8.
9.
Use dental oss or heat shrink tubing
to secure the connection between the
servo and extension wire so they cannot
become unplugged accidentally.
Remove the string from the wing at the
servo location and use the tape to attach it
to the servo extension lead. Pull the lead
through the wing and remove the string.
10.
11.
12.
Set the aileron hatch in place and use a
Phillips screw driver to install it with four
wood screws.
M3x10mm
13.
To Next Page
Loading...
