YAK 55. Instruction Manual
8
Fuel pick-up tube.
Fuel fill tube.
Vent tube.
Blow through one of the lines to ensure
the fuel lines have not become kinked in-
side the fuel tank compartment. Air should
flow through easily.
9) Connect the lines from the tank to the
engine and muffler. The vent line will connect
to the muffler and the line from the clunk to the
carburetor.
Pushrod wire.
1) Locate the items neccessary to install
the wheel and wheel pants as shown.
WHEEL AND WHEEL PANTS
INSTALLATION.
Repeat steps as above to attach remain-
ing wheel pants to the landing gear.
2) You have to trim each axle using a tool
cutting and cut-off wheel.
Caution when cutting the axles and
wear protective goggles.
Aluminum landing gear
.
To Next Page