www.seagullmodels.com
9
9) Connect the lines from the tank to the
engine and muffler. The vent line will connect
to the muffler and the line from the clunk to the
carburetor.
WHEEL AND WHEEL PANTS
INSTALLATION.
Fuel pick-up tube.
Fuel fill tube.
Vent tube.
10mm.
4.2mm.
Blow through one of the lines to ensure
the fuel lines have not become kinked in-
side the fuel tank compartment. Air should
flow through easily.
1) Locate the items neccessary to install
the wheel and wheel pants as shown.
2) Follow diagram below for wheel pant
installation:
Use a drill and 4.2mm drill bit to drill a hole in
the wheel pants.
Drill a hole.
3) You have to trim each axle using a tool
cutting and cut-off wheel.
Caution when cutting the axles and
wear protective goggles.
46mm
To Next Page
Loading...
